torque settings

[black 86 supra]

ok, I'm being lazy, I know its been mentioned before,

what rate should the head on a 7mgte be retorqued to after a new hg?

[Dino]

http://www.supras.org.nz/techinfo/TSRM/25_B.pdf

[Lofty]

http://www.supras.org.nz/techinfo/TSRM/25_B.pdf
That is standard torque settings.
Recommended setting will depend on your gasket type and fixings.

OEM HG with OEM headbolts is recommeded to be somewhere between 65 to 72ft/lbs. Best not to re-use OEM bolts if they have been used at this setting before.

[black 86 supra]

That is standard torque settings.
Recommended setting will depend on your gasket type and fixings.

OEM HG with OEM headbolts is recommeded to be somewhere between 65 to 72ft/lbs. Best not to re-use OEM bolts if they have been used at this setting before.


stock 1.0mm ( aftermarket HG ) with ARP Bolts, 1st torqued to 72, what should it be retorqued to?

[Nick@TC]

On an OEM gasket you don't want to go any higher than 72llb/ft wether it be arp studs/bolts e.t.c